Instructions For Installing Log Set - Kingsman HBZDV4740 Installation Instructions Manual

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
LOG 1
LOG 2
LOG 3
LOG 4
STEP 1: Log 1 is to be positioned onto Pin 1 with locating hole on bottom
of log. The rear right of Log 1 will be placed against stop. (Do not place
log on top of stop.)
PIN 3
PIN 2
STEP 2: Locate the two holes on bottom of Log 2 and position these down
onto the locating Pins 2 and 3.
❷
STEP 3: Place log 3 behind the rear burner tube as shown in the
photograph.
❸
❷
Instructions for installing Log Set C-60
for Models HBZDV4740
LOG 5
LOG 6
LOG 7
LOG 8
STOP
PIN 1
❶
LOBE
❶
STEP 4: (Note hole on Log 4, bottom of main knot and flat area near end of log.)
Raise Log 3 approx. 2 inches and position Log 4 under the top knot of Log 3. Position
the hole of Log 4 onto locating lobe of Log 1, lower Log 3 down into place as shown.
Place flat area of Log 4 onto left rear burner log mount and push back against tab.
❷
STEP 5: Place Log 5 against grate bars and position Log 6 along side of
Log 5 and onto Log 1 as shown in the photograph.
❷
STEP 6: Place the narrow end of Log 7 onto Log 4. The left front of Log
7 should touch the firebox wall or brick panel.
STEP 7: Place Log 8 onto Log 3. The right front of Log 8 should touch
the firebox wall or brick panel. Verify that Logs 7 and 8 do not extend into
the glass front or enter into the flame path.
❼
❷
STEP 8: Place a small amount of glowing ember material
front burner tube ends. (Too much ember material causes a blue flame.)
(When placing embers onto burner, leave an air space between the log
and the embers; this will help produce a yellow flame in these areas.)
Place rocks onto false bottom only. Do not place rocks onto burner tubes.
R
❼
❷
E
R
R
❸
❹
❶
❸
❹
❶
❻
❺
❸
❹
❽
❶
❻
❺
E
onto the
❸
❹
❽
❶
❻
❺
E
R
R
30