Door And Glass Information - Kingsman HBZDV4740 Installation Instructions Manual

Glass Cleaning
It will be necessary to clean the glass periodically. During start-up, condensation, which is normal, forms on the inside of the glass and
causes dust, lint etc. to cling to the glass surface. Also, initial paint curing can deposit a slight film on the glass. It is therefore recom-
mended that initially the glass be cleaned two or three times with
After that, the glass should be cleaned two or three times a season depending on the circumstances.
Warning and Cautions.
• Do not clean when the glass is hot.
• Do not use abrasive cleaners.
• Using a substitute glass will void all product
warranties.
• Do not strike or abuse glass. Care must be
taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass
front or with a broken glass.
Glass Replacement
REPLACEMENT GLASS FOR DIRECT VENT UNIT
Model Series HBZDV4740 use Low E tempered glass. Must be 5mm thick.
To replace glass, clean all materials from door frame. Scrape off old silicone down to metal. Using a high heat silicone temperature-
resistant to 500°F (260°C) apply a continuous bead of approximately 1/32" to all four sides of frame and insert glass with new gasket.
Frame should be on flat surface, with a small amount of weight pressing glass into silicone. Let dry approximately 15 to 20 minutes. The
door can be re-installed by reversing Steps 1 & 2. Use caution when removing broken glass, wear gloves.
Removal of the Glass Door
1. Remove the door by unlatching the 2 top latches. Simply place 2 fingers in the grooves, pull towards you and lift upwards slightly.
2. Once the top of the door is unlatched, simply pull outwards and lift upwards to unlatch the bottom.
3. When re-installing the door place the bottom of the door in first and secure with Top Latch assembly to the door.
Spring Replacement:
*Over time, spring may need to be replaced if tension is lost.
1. To remove the top latch, remove the 2 hex screws that secure it in place. They are located in the firebox.
2. Once all the screws are removed the latches will slide out of place.
3. There is 1 lock nut per latch. When replacing a spring, tighten the lock nut until 2 threads are beyond the locknut. This is critical for
proper tension.

Door and Glass Information

non-abrasive common household glass cleansers and warm water.
17