Mantel Leg Clearances - Kingsman HBZDV4740 Installation Instructions Manual

Mantel Leg Clearances

Mantels
Depending on the depth of the fireplace mantel, it may be installed higher or lower from the top of the fireplace opening. See drawings
for proper installation height of your combustible mantel. Non-combustible mantels may be installed at any height above the fireplace
opening.
Non combustible materials such as brick, tile, etc. can extend up to or over the front face of the fireplace (NO PORTION OF GRILL
AREA OR DOOR AREAS CAN BE COVERED) except where designer clean view kit is used.
Combustible material can extend flush to unit up to the top, bottom and sides of fireplace to stand-offs.
For COMBUSTIBLE materials extending in front of fireplace consult (Mantel and Mantel Leg Drawings).
Surrounds
If installing wide or slim line surrounds, the finish materials must be flush with the front facing of the fireplace. See page 6 figure 'A', the
floor should be built up 1" in front of the fireplace in order for the surrounds to sit flush to the floor.
Note: When using paint or lacquer to finish the mantel, such paint or lacquer must be heat resistant (250˚F) to prevent
discoloration.
Warning: Combustible objects must not
be placed on a non-combustible mantel
unless the non-combustible mantel
meets the minimum height and width
requirements for a combustible mantel.
13