Burner System Maintenance; Conversion Kit Instructions - Part A - Kingsman HBZDV4740 Installation Instructions Manual

Zero clearance direct vent fireplace

Hide thumbs Also See for HBZDV4740:

Installation instructions manual (38 pages)

Table Of Contents

Table of Contents

It is recommended to annually inspect and clean the Burner System to prevent malfunction and / or sooting. This

operation should be performed by your dealer or a qualified technician.

Before servicing the burner system ensure that the gas supply is turned OFF and disconnect all

electrical connections to the appliance. Allow the appliance to cool to room temperature. Note

that the pilot assembly may be hot in an intermittent or standing-pilot system—even if the main

burner was never on. Exercise caution when working within the area.

-ALL WORK SHOULD BE PERFORMED BY A QUALIFIED AND CERTIFIED TECHNICIAN-

Monthly Flame Inspection

It is recommended to turn on the unit at least once a month and inspect the flame pattern to ensure there are no problems

with the burner tube. The pilot flame should also be inspected monthly to ensure proper operation.

Flame should appear similar to the above picture.

Kit Number

Description

LP Conversion

4740HB -CKLP

-Millivolt-

NG Conversion

4740HB -CKNG

-Millivolt-

LP Conversion

4740HB -CKLPI

-IPI -

NG Conversion

4740HB -CKNGI

- IPI -

Refer to "Gas Specifications Chart" for inlet pressures and input ratings. Clock meter to verify input rate. Place conversion label

as close to converted gas control as possible. Refer to lighting instructions to verify the normal operating sequence of the ignition

system. IMPORTANT: Always check for gas leaks with a soap and water solution. DO NOT USE OPEN FLAME FOR LEAK

TESTING.