Installing The Receiver And Battery; Belly Pan Installation - Seagull Models Extra 300S Assembly Manual

EXTRA 300S

INSTALLING THE RECEIVER AND BATTERY

! ! ! ! ! 1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
! ! ! ! ! 2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration
! ! ! ! !
3)Position the battery pack in the fuel
tank compartment and the receiver just be-
hind the fuel tank . Use extra foam pieces to
hold them in position.
When balancing the airplane you may
need to move the battery or receiver for-
ward or after to achieve proper balance.
! ! ! ! ! 4) Using a 1/16" drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit. Route the antenna out of
the fuselage and secure it to the vertical stabi-
lizer using a rubber band and a modified servo
arm. See picture as below.
Antenna
Modified
Servo Arm

BELLY PAN INSTALLATION

! ! ! ! ! 1) Bolt the wing to fuselage.
! ! ! ! ! 2) Place the belly pan into its positon un-
der the wing centre section, Trim where nec-
essary, marking sure it aligns with the wing
and fuselage.
! ! ! ! ! 3) Remove the covering where the belly
pan contacts the wing. Do not cut into the wing
when removing the covering. Glue into posi-
tion onto the wing with C/A glue.
18
Cut
Rubber
Band
Instruction Manual
C/A glue