Installing The Receiver And Battery - Seagull Models SEAGULL 40 Assembly Manual

SEAGULL 40
LOW WING TRAINER.
ELEVATOR-RUDDER PUSHROD
INSTALLATION.
Elevator pushrod.
Rudder pushrod.
Clevis.
Adjustable Servo connector.
(1 PCS).
Thread locker glue.
Switch.
Throttle.

INSTALLING THE RECEIVER AND BATTERY.

1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration
14
Control
horn.
Servo arm.
(2 PCS).
Rudder.
Elevator.
Instruction Manual.
Antenna wire.
Antenna.
Tie wrap.
ATTACHMENT WING - FUSELAGE.
See picture below:
Wing bolt.
BALANCING.
1) It is critical that your airplane be bal-
anced correctly. Improper balance will cause
your plane to lose control and crash. The cen-
9cm
ter of gravity is located
ing edge of the wing, measured at the wing
tip.
Battery.
Receiver.
back from the lead-