Operation Controls And Functions; Front Panel - CYP CMSI-8H8CV Operation Manual

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

8X8 HDMI MATRIX over CAT5e/6 CMSI-8H8CV
1
1 LCM: Displays the setting information of each input and output
setting.
2 POWER: Press this button to power the device on/off. The LED will
illuminate green when the power is on, red when it is in 'Standby'
mode.
3 LOCK: Press this button to lock all the buttons on the panel; press
again to unlock. The LED will illuminate green when locked.
4 IR: IR Receiver window (accepts the remote control signal of this
device only) with IR frequency of 38 kHz.
MENU: Press this button to access the LCM menu system, from
5
here EDID settings can be managed and IP system settings are
displayed.
6 1~8/A~H and OUT/IN: Press the OUT or IN button to select the
output or input mode and then press the required number button
to make the selection accordingly.
For example, if outputs A~D need to be set to input 1 and outputs
E~H need to be set to input 2, then the following sequence of
button presses need to be performed:
Press: OUTABCDIN1MENU,
and then press: OUTEFGHIN2MENU.
Note: If the MENU button is not pressed the selection will not be
changed.
3
POWER LOCK
2 3 4
MENU A 1 B 2 C 3
E 5 F 6 G 7
5 6
D 4 OUT
H 8 IN