Table of Contents
Advertisement
(Figure 5-1)
BDA TELE SSC 1 11_08 D.indd 10
5 F ir st installation
After you have gone through the safety instructions
and connected the device as described in Chapter 4,
switch on the device now as described in Chapter 7.
During the first commissioning of the device the menu
"Installation done" appears (Figure 5-1). Here you can
do the most important settings of the digital receiver
in an easy way.
5.1 Language
In this menu option you can select the language, in
which the on-screen displays are to be shown.
>
Highlight the row of the OSD-language with the
up/down arrow buttons.
>
Press the button OK. A window opens showing
the available operating languages.
>
Select the desired language with the up/down
buttons and confirm with OK.
5.2 Adjusting the receivers to the
reception system
You can now adjust the settings of your digital receiver
to the configuration of your antenna. From the factory
the receiver is set to the satellites ASTRA 19.2° (Port
A), Eutelsat/ Hotbird (Port B) and Türksat 1c (Port C).
If you do not want to receive any other satellite, you can
accept the factory setting as such by pressing the green
button.
Satellite 1
>
Highlight the row SAT A with the up/down
buttons.
>
Press OK. A window opens with the available
satellites.
>
Select the satellite with the arrow buttons
up/down or page up/down, which you receive
with the DiSEqC-setting position A/option A and
confirm with OK.
Satellite 2
>
Highlight the row SAT B with the up/down
buttons.
>
Press OK. A window opens with the available
satellites.
>
Select the satellite with the arrow buttons
up/down or page up/down, which you receive
with the DiSEqC-setting position B/option A and
confirm with OK.
10
01.01.1970 2:45:32 Uhr
Advertisement
Table of Contents
