Table of Contents
Advertisement
>
By pressing the TV/Radio button again the last
viewed TV channel is set.
7.6 Return to the last channel set
>
Press the button Back on the remote control to set
the last viewed channel again.
>
Press the button again to view the channel you
were viewing last.
7.7 Transponder-Info
>
Press the button Info to view the data of the
transponder set (Figure 7-6).
>
Press the button Exit to return to the normal
mode.
7.8 Video text
If transmitted, you can use the built-in video-text
decoder to view the video-text information of the
individual channels.
>
Switch on the channel, for which you wish to
view the video-text information.
>
Activate the video-text by pressing the yellow
button Videotext (Figure 7-7).
>
With the help of the numeric keypad enter the
desired video-text page. Your input is shown in
the top left corner of the screen. After you
enter the desired video-text page, the device
searches for the page.
Since all the video-text pages cannot be
transmitted at the same time, it can take a few
seconds, till the device locates your page and
shows it on the screen.
In case of all video-text operators the page 100
shows the table of contents.
>
Use the arrow buttons left/right to browse through
the pages.
Press the button Exit to come back to the normal mode.
7.9 Sub-titles
Some broadcasters also transmit the subtitles. Proceed
as follows to activate the display of the sub-titles:
BDA TELE SSC 1 11_08 D.indd 23
(Figure 7-6)
ch
en,
(Figure 7-7)
01.01.1970 2:45:51 Uhr
Advertisement
Table of Contents
