Table of Contents
Advertisement
BDA TELE SSC 1 11_08 D.indd 48
For the daily use
Switch on and off
>
Switch on the receiver by pressing the button
On/Standby on the remote control or at the
device.
>
Pressing this button again switches off the
device.
>
The device is now in ready mode (standby), the
time is thereby shown in the display on the
device.
Channel selection
With the channel up/down buttons
>
Switch the channels one space up and down
with the help of the channel buttons up/down
on the remote control or at the device.
With the help of numeric keypad
>
Enter the desired channel number with the help of
the numeric keypad. For example:
1
1,
then 4
2,
then 3,
then 4
When entering multi-digit channel numbers, you have a
time of about 3 seconds after pressing a button to
complete your input.
If you wish to enter only a single- or two-digit
number, you can accelerate the switching process by
keeping the last number pressed for a longer time.
With the help of channel list:
>
Press the OK button.
>
You can now highlight the desired channel with
the help of the channel up/down arrow buttons.
>
Press the OK button to set the highlighted
channel.
>
With the help of the up/down arrow buttons you
can move the marker by one space in the list.
>
With the buttons Page up/down you can go up
and down one page in the list.
Volume control
>
Control the volume of your receiver with the
help of the buttons Volume + f or louder a nd
Volume – for softer.
>
The sound can be switched on/off by pressing
the button Sound on/off.
for channel number 1
for channel number 14
for channel number 234
01.01.1970 2:46:07
Advertisement
Table of Contents
