Table of Contents
Advertisement
The menu Antenna settings help (Figure 6-
14) appears.
>
Highlight the row Satellite with the up/down
buttons and confirm with OK.
A list with the available satellites appears.
>
With the up/down buttons select the desired
satellite. If the desired satellite is not
available in the list, select a freely definable
satellite e.g. Newsat 01.
>
If you have selected a freely definable
satellite, enter the position in both the next
two rows with the help of numeric buttons
and arrow buttons.
>
Highlight the row Longitude with the
up/down arrow buttons.
>
Enter the longitude of your location with the
help of numeric keypad.
>
In the next row, enter with the help of left/right
buttons, whether it is an eastern or western
longitude.
>
Similarly, enter also the latitude of your
location.
>
Highlight the row Calculate with the up/down
buttons and confirm with OK.
The result now appears on the screen with the
elevation and azimuth angle.
>
You can return to the normal operation by
pressing the Exit button several times.
7 Operation
7.1 Switch on and off
>
Switch on the receiver by pressing the button
On/Standby on the remote control.
>
The device is switched off if you press this button
again.
>
The device is now in the ready mode (standby)
>
During operation the LED on the receiver glows
in green, during standby in red.
7.2 Channel selection
7.2.1 With the help of Channel up/down buttons
>
Switch the channels with the help of the buttons
BDA TELE SSC 1 11_08 D.indd 19
hen
(Figure 6-14)
1
01.01.1970 2:45:48 Uhr
Advertisement
Table of Contents
