Table of Contents
Advertisement
BDA TELE SSC 1 11_08 D.indd 36
>
Set the transponder with left/right buttons, which
you want to search. If you wish to modify the data
of a transponder or enter the data of a new
transponder , then proceed as follows :
>
Set the transponder with left/right buttons, which
you want to modify. To enter a new transponder, set
the transponder with the highest consecutive
number.
>
Press the red button for editing mode.
You can now modify the data of the transponder.
Frequency
>
Highlight the row Frequency with the up/down
arrow buttons.
>
Enter the frequency of the desired transponder
with the number keys.
Symbol rate
>
Highlight the row Symbol rate with the up/down arrow
buttons.
>
Enter the symbol rate of the desired transponder
with the number keys.
Polarity
>
Highlight the row Polarity with the up/down arrow
buttons.
>
Enter the polarity of the desired transponder with the
left/right arrow buttons .
22 KHz
>
Highlight the row 22 KHz with the up/down
buttons.
>
Switch on or off the 22 KHz control signal with the
left/right arrow buttons.
This setting can be made only when a C-Band LNB has
been set in Point 6.4.
>
To come out of the input mode, press the red button
Input Mode.
Start search
>
Highlight the lowermost row of the input menu with
the up/down arrow buttons.
>
Set the search type Transponder with the left/right
arrow buttons.
>
Press OK to start the search. Pay attention to the
on-screen messages being shown.
01.01.1970 2:46:00 Uhr
Advertisement
Table of Contents
