Table of Contents
Advertisement
(Figure 8-10)
(Figure 8-11)
BDA TELE SSC 1 11_08 D.indd 34
3. Transponder search
Select this search to search specifically for a transponder of
a satellite.
4. Manual search
Select this search to search specifically for a channel using
the channel-specific PID numbers. After the search the new
channels are stored in the complete list and can then be
included in the favourites list as described in Point 8.1.4 .
>
Open first the Main Menu for channel search. (Figure
8-10)
>
Highlight the row User Installation with the help of
up/down buttons.
>
Confirm with OK.
>
Highlight now the row Channel Search and confirm
with OK. The menu Channel Search now appears.
(Figure 8-11)
8.2.1 Satellite search
Proceed as follows to search a satellite for channels:
Antenna
>
Highlight the row Antenna with the up/down buttons.
>
Set the antenna with the left/right arrow buttons, with
which the satellite you want to search for new channels
is received.
Satellite
>
The satellite assigned to this antenna as per Point 6.4
now appears in the row Satellite.
Position
The row Position is active only when the satellite position set
in the row Antenna is received with a rotating system
(DiSEqC 1.2). Please note here Point 8.3.6.
Start search
>
Highlight the lowermost line of the input menu with the
up/down buttons.
>
Set the search type Search 1 with the left/right arrow
buttons. When using a rotating system, you can also set
the search type Search All. In this type of search all the
satellites being received by the rotating system are
searched for channels.
01.01.1970 2:45:59 Uhr
Advertisement
Table of Contents
