Table of Contents
Advertisement
>
Set the weekday with the left/right buttons, on
which the timer event should take place.
Confirm with OK. Enter the duration of the timer event
with the help of the numeric keypad and confirm with
OK.
7.11.2 Change timer programming
>
To modify an existing timer event, highlight
the corresponding timer number with the arrow
buttons and modify the entries as described
above.
7.11.3 Deacti vat e timer programming
>
To deactivate an existing timer event,
highlight it with the arrow buttons.
>
Highlight the row Activate with the up/down
buttons.
>
Set No with the left/right buttons, in order to
deactivate the timer event. Return to the normal
mode by pressing the EXIT button several times.
Caution!!!
Please pay attention that the clock time is recorded in
the device. This is shown in the display in the standby
mode. If this is not the case, leave your device
switched on for about 30 seconds to e.g. ZDF, so that
the clock time can be read.
The time should now be shown in the standby mode.
7.12 Rotating the antenna manually (rotating system)
When using a rotating system, the position of the
antenna can be set or adjusted manually.
>
Press the green button in the normal mode. A
menu window appears (Figure 7-11).
>
Rotate the antenna by pressing the arrow button
right (West) or left (East), till the desired
position is reached.
>
Return to the normal mode by pressing the Exit
button.
8 C h a n g in g base programming
Ex-factory the device is preset with a base
programming, which contains the programmes of
ASTRA 19.2° East, EUTELSAT 13° East and
TÜRKSAT.
BDA TELE SSC 1 11_08 D.indd 27
(Figure 7-11)
01.01.1970 2:45:54 Uhr
Advertisement
Table of Contents
