3D Systems Cube 2nd Generation User Manual page 43

24
REPLACING MATERIAL CARTRIDGE
Do not change cartridge or material during printing; doing so can cause damage to your Cube.
If your material cartridge does not have enough material to complete your creation; you will need to replace your cartridge. It
is important that the same color of material that is being used must be installed. Do not change to a different color of mate-
rial; doing so can cause damage to your Cube. Please follow these steps to replace the cartridge.
1. Pull Cube Tube away from top of print jet. Please do not pull the
material out until the touch screen instructs you to do so.
2. Pull material out of print jet and press "Next."
NOTE: After the material is pulled out from the print jet. It may be necessary to remove material debris from the
print tip that could be clogged in the print tip. Using the unclog tool, insert the tool's point into the print jet; if
debris is present, it will protrude from the print tip.
Pull Material Out
3. Remove cartridge from Cube and remove the Cube Tube from material. Re-
place thumb screw into cartridge to hold the unused material in place. Refer
to "Material Cartridge Installation," for instructions on how to install your new
cartridge.
Thumb Screw
50
Cube
Tube
Cube
Tube
Unclog Tool