Wiring For Vehicles With 16-Pin Mirror Connector - BrandMotion 9002-9521 Installation Instructions Manual

Section 6C: Wiring for vehicles with 16-pin mirror connector
31. On the supplied interior harness, near the black 16
pin connector, locate the seven loose wires. (Figure
24)
32. Isolate the pink wire with electrical tape as it will not
be used.
33. Using the Connector C9039 pinout diagram opposite,
splice the remaining six wires to the vehicle mirror
harness wires according to Diagram A2.
Diagram A2
Supplied
Interior
Harness
Wire Color
Red +
Green +
Black -
Yellow
Pink
Orange +
White -
34. If you removed the compass circuit board, per
section 6A: On the supplied interior harness, locate
the five loose wires near the white 6-pin connector.
(Figure 25)
35. IMPORTANT: Isolate the red wire with electrical tape
as it will not be used.
36. Using the Connector C9039 pinout diagram opposite,
splice the remaining four red, green, black, and
yellow wires to the vehicle mirror harness connector
removed in Step 24 according to Diagram A2.
37. If you did not remove the compass circuit board,
isolate the five loose wires with electrical tape, as
they will not be used.
IMPORTANT: If reverse signal does not exist
in pin 9 of 16-pin mirror C9039 connector (see
diagram below), then follow directions in
Section 7 to connect reverse.
9521 Instructions 2-12-15.doc
INSTALLATION INSTRUCTIONS
Splice to
Wire at
C9039
Function
Location
Ignition pin 1
Reverse pin 9
Ground pin 4
pin 2
(if present)
Not used –
Isolate with
electrical tape
Auto Dimming
pin 11
Mirror
Auto Dimming
pin 15
Mirror
10 of 35
NOTE: Circuit colors
shown may vary
depending on model
and year. Verify pin
locations and check
circuit for proper
function using a digital
volt-ohm meter.