Dimming (If Required) - BrandMotion 9002-9521 Installation Instructions Manual

Section 7: Inside Rear View Mirrors without Auto Dimming
Follow the steps in Section 7 only if the vehicle does not have an auto dimming inside
rear view mirror.
44. Remove the passenger side door sill plate with a
trim tool and remove passenger side kick panel with
hands, just disengaging the two clips from the sheet
metal (Figure 31).
Figure 31
45. Isolate the seven wires near the black 16-pin
mirror connector on the supplied interior harness
(Figure 32) with electrical tape along with the pink
and yellow wires near the white 6-pin connector
(Figure 33).
Figure 32
9521 Instructions 2-12-15.doc
INSTALLATION INSTRUCTIONS
Cover seven
unused wires.
with tape.
46. Route the supplied interior harness green, red, and
black wires along the vehicle cross dash harness.
Secure using wire ties wherever possible at 2 inch
intervals.
47. Splice the green reverse wire from the supplied
interior harness white 6-pin connector end to the
wire listed in Diagram A3, on the next page,
depending on the vehicle model. Solder and cover
the connection with tape or heat shrink tubing.
48. Splice the red ignition wire from the supplied interior
harness white 6-pin connector end to the wire listed
in Diagram A3, on the next page, depending on the
vehicle model. Solder and cover the connection with
tape or heat shrink tubing.
49. Attach the black ground wire eyelet from the
supplied interior harness white 6-pin connector end
to sheet metal in the passenger side kick panel with
a screw using an 8mm socket (Figure 34).
12 of 35
(if required)
Figure 33
Cover unused pink &
yellow wires with
tape.
Figure 34