Advertisement
4. Run the camera harness along the under
hood covering, down the drive side hinge.
Zip tie the harness to the hinge so the
harness will not kink or cut.
5. Run harness into the vehicle though the
factory grommet in the drivers side firewall.
6. Route the camera harness to the location of
the 360º module.
Side Mirror Camera installation
1. The inter door panel will have to be
removed for installation of the side
cameras.
2. Working on the driver side door. With the
door closed, place the template sticker
( marked LHD ) on the bottom side of the
mirror with arrow aiming away from the
vehicle. Perpendicular to the side of the
body. ( Do not go by mirror lines or angles .)
3600 Instructions 9-1-15
!
Section 2:
INSTALLATION!INSTRUCTIONS!
3. Make sure the template is to at least the
middle to outer edge of the mirror. ( The
camera needs to see only a little of the side
of the vehicle and mainly the ground and
objects next to the vehicle .)
4. Remove the door panel and the 3 nuts that
are holding the mirror to the vehicle.
5. Place the mirror on a soft or padded surface
and remove the glass from the mirror.
( Each vehicle is different, but most are
mounted by a center circle and will unclip
from it .)
6. After the glass is removed, check to see if
where the templates are placed there is
clearance for the camera and will not cut
into anything in the mirror housing. ( If the
template has to be moved make sure to
keep the arrow aiming the same way .)
7. Drill a hole in the bottom of the mirror using
a hole saw or Uni-bit to the size on the
template. Which is 1 1/8"
Page 2 of 19
Advertisement
