Section 3: Modify Rain Sensor; Section 4: Remove Mirror - BrandMotion 9002-9521 Installation Instructions Manual

Section 3: Modify Rain Sensor

(If equipped
Follow Steps 10 and 12 on this page
only if you have a rain sensor module
mounted on your inside rear view
10. Remove rain sensor by pulling down and remove
connector (Figure 10).
Figure 10
11. Using a round file, open up the rain sensor
opening for mirror by 0.46mm so the supplied
mirror fits (Figure 11).
Figure 11
9521 Instructions 2-12-15.doc
INSTALLATION INSTRUCTIONS
)
mirror.

Section 4: Remove Mirror

12. If you did not already do so previously, start the
vehicle and note location of compass display. Unplug
the mirror connector from mirror (Figure 12).
13. If the compass display on the dash shows (- -) the
compass module must be relocated. This operation
is described in Section 6.
14. Loosen the screw that attaches the existing rear view
mirror to the windshield mounting button with a T20
Torx driver (Figure 13).
CAUTION: Removing the mirror from the windshield can
cause damage to the windshield. It is highly
recommended to contact either a Ford dealership
or a windshield replacement company. Otherwise,
slide the mirror upwards and towards the rear to remove
it from the windshield (Figure 13).
NOTE: On some models without screws, Mirror
Removal Tool # OTC8200 is required.
5 of 35
Figure 12
Figure 13