15. Remove driver side dash panel end cap by pulling
away weather-stripping and pull end panel to
release clips from the dash panel (Figure 14).
Figure 14
16. Remove driver side A-pillar by pulling with hands to
release clips from sheet metal (Figure 15).
Figure 15
17. Remove both sun visor anchors (either side of roof
console) by removing one screw with a Phillips
screwdriver (Figure 16).
Figure 16
9521 Instructions 2-12-15.doc
INSTALLATION INSTRUCTIONS
Section 5: Install Interior Harness
18. Remove roof console with hands to remove the clips
from the sheet metal. Then remove both connectors
(Figure 17).
19. Route the supplied interior harness under leading
edge of the driver side headliner by gently
separating the headliner from the windshield and
tucking the harness into the gap with your fingers
(Figure 18).
20. Route the supplied interior harness down the driver
side A-pillar (Figure 19).
6 of 35
Figure 17
Figure 18
Figure 19