BrandMotion 9002-9521 Installation Instructions Manual page 19

Section 9: Chassis Harness Installation continued
57. Center punch and drill a pilot hole.
58. Drill a 1/2 inch hole, clean the hole with a deburring
tool (Figure 41).
Figure 41
59. Apply supplied Z-tech with a small brush (Figure
42).
Figure 42
60. Route the supplied chassis harness through the
drilled opening and seat the grommet from the
inside of vehicle (Figure 43).
9521 Instructions 2-12-15.doc
INSTALLATION INSTRUCTIONS
61. Route the supplied chassis harness toward the
supplied interior harness and connect the RCA
connectors together. Then connect the red and
black camera chassis harness wire to the red and
black wires from the RCA of the interior harness
(Figure 44).
19 of 35
Figure 43
Figure 44