Product Information; Intended Purpose; Test Marks; Materials Used - Judo QUICKSOFT-UNO Installation And Operating Instructions Manual

3.

Product Information

The units conform to the technical regula-
tions for drinking water installations in
accordance with DIN 1988.
3.1

Intended purpose

This softener is suitable for use in cold drink-
ing water up to a maximum water tempera-
ture of 30°C (86°F).
ATTENTION
(see chapter "Safety information and dan-
gers due to non-compliance")
Please refer to the chapter "Intended Use"
for use restrictions.
This softener is used to protect the water
pipes and hot water heater against lime-
scale deposits.
Partly softened water protects appliances
and fittings and reduces consumption of de-
tergents and cleaning agents.
Limescale deposits inhibit water
flow and can therefore result in in-
creased energy consumption.
8
Product Information
3.2
DIN-DVGW mark
Fig. 3:
The units conform to the technical regula-
tions for drinking water installations in ac-
cordance with DIN 1988. They are tested by
the DVGW (Deutsche Vereinigung des Gas-
und Wasserfaches e.V., i.e. the technical-
scientific association for the gas and water
industries) in accordance with the require-
ments of DIN EN 14743 and DIN 19636-100
for softeners (cation exchangers) in drinking
water installations and are entitled to bear
the DIN-DVGW mark (see Fig. 3).
3.3
The materials used are resistant to the
physical, chemical and corrosive loads to be
expected in the drinking water and fulfil the
requirements specified in the DIN EN 14743
and DIN 19636-100 standards ("Softeners
(cation exchangers) in drinking water instal-
lations"). All materials are hygienically and
physiologically safe. Plastics fulfil the official
guideline of the German Federal Environ-
mental Agency. Metallic materials fulfil the
requirements of the DIN 50930-6 standard
(Impact on the drinking water quality).
JUDO QUICKSOFT-UNO

Test marks

Test marks

Materials used