Starter - Kubota WSM OC60-E2 Workshop Manual

OC60-E2, OC95-E2, WSM

(11)Starter

Disassembling Starter (OC60-E2)
(1) Plug
(2) Bushing
(3) Starter Drive Housing
(4) Magnet Switch Mounting
Nut
(5) Drive Lever
1. Unscrew the mounting nut (9), and disconnect the connecting lead (17).
2. Unscrew the magnet switch mounting nut (4).
3. Remove the magnet switch (8) by sliding it up so that it is disconnected from the drive lever (5).
4. Unscrew the two through bolts (14).
5. Remove the end frame (22).
6. Remove the insulator (20).
7. Remove the brush (16) and brush spring (19), and pull out the brush holder (18).
8. Draw out the yoke (15) from the starter drive housing (3).
9. Draw out the armature (13) with the drive lever (5).
When removing the insulator (20), from popping out like a bullet.
When removing the brush (16), prevent the brush spring (19) from popping out like a bullet.
(6) Pinion Stop Nut
(7) Gasket
(8) Magnet Switch
(9) Nut
(10) Washer
(11) Snap Ring
(12) Overrunning Clutch
(13) Armature
(14) Through Bolt
(15) Yoke
(16) Brush
(17) Connecting Lead
S-37
ENGINE
(18) Brush Holder
(19) Brush Spring
(20) Insulator
(21) Bushing
(22) End Frame
(23) Cover