OC60-E2, OC95-E2, WSM
(10)Injection Nozzle
Nozzle Holder
1. Secure the nozzle holder body (9) with a vise.
2. Remove the nozzle holder (1), and take out parts inside.
(When reassembling)
Assemble the nozzle in clean fuel oil.
Install the push rod, noting its direction.
Nozzle holder body
Tightening torque
and nut
Since the nozzle piece is precision finished, a piece of
wood must be used to remove carbon deposit. Do not use
pieces of metal.
After assembling the nozzle, be sure to adjust the fuel
injection pressure.
(1) Nozzle Holder
(2) Nozzle Body
(3) Needle Valve
(4) Nozzle Piece
(5) Distance Piece
S-36
ENGINE
97 to 116
10 to 12
73 to 88 ft-lbs
(6) Push Rod
(7) Nozzle Holder
(8) Adjusting Washer
(9) Nozzle Holder Body
0000009250E