Relief Valve - Kubota WSM OC60-E2 Workshop Manual

OC60-E2, OC95-E2, WSM

(9) Relief Valve

Governor Lever 1, 3 and Governor Spring (OC95-E2)
(When reassembling)
Clean up the governor lever 2 (7) and the shaft hole. Apply oil
to them.
Install the oil seal (1) onto the crankcase.
Make sure the bearing (6) of the governor lever 1 (5) moves
smoothly.
Assemble the governor lever 1 (5) and 2 (7).
Put the governor lever 2 into the crankcase hole.
Hook the idle spring (4) into position.
Position the stop lever of the speed control lever shaft
behind the governor lever 1 (5). See the figure.
Install the governor lever 3 (2) from outside the
crankcase.
Put the spring pin (3) and see if there is a clearance of 0.1
to 0.3 mm in the axial direction.
Pull the speed control lever toward the stop position
(toward the side cover), and hook the governor spring.
Hook the governor spring to the governor lever 3 (2) first
and then into the second hole from outside in the speed
lever.
(1) Oil Seal
(2) Governor Lever 3
(3) Spring Pin
(4) Idle Spring
Relief Valve
1. Two relief valves are installed, one is on the top of the side
cover and the other one is in cylinder head.
2. Remove the eye joint bolt and take out the spring and ball.
S-35
ENGINE
(5) Governor Lever 1
(6) Bearing
(7) Governor Lever 2
0000009247E
0000009249E