Kubota WSM OC60-E2 Workshop Manual page 104

OC60-E2, OC95-E2, WSM
Overrunning Clutch (OC60-E2)
1. Inspect the pinion for wear or damage.
2. If there is any defect, replace the overrunning clutch assembly.
3. Check that the pinion turns freely and smoothly in the
overrunning direction and does not slip in the cranking
direction.
4. If the pinion slips or does not rotate in the both directions,
replace the overrunning clutch assembly.
Brush Holder (OC95-E2)
1. Check the continuity across the insulated brush holder and the
brush holder support.
2. If continuous, replace the brush holder assembly.
Field Coil
1. Check the continuity across the lead (1) and brush (2) with an
ohmmeter.
2. If it does not conduct, replace the yoke assembly.
3. Check the continuity across the brush (2) and yoke (3) with an
ohmmeter.
4. If it conducts, replace the yoke assembly.
(1) Lead
(2) Brush
S-52
ENGINE
0000009307E
0000009313E
(3) Yoke
0000001173E