Kubota WSM OC60-E2 Workshop Manual page 85

OC60-E2, OC95-E2, WSM
Side Bearing (Crank Case)
(When removing)
Lift up the side bearing by the flat screw driver as shown in
figure.
(When reassembling)
Make sure the oil groove (1) in the side bearing comes toward
the crank gear.
Make sure the anti-fall spring pin (2) for the side bearing is not
stretching out of the bearing surface.
Keep the spring pin head A above the surface (not greater
than the side bearing thickness of 2 mm).
Do not confuse the above side bearing with that at the
crankcase.
OC60-E2
Spring pin head A
OC95-E2
(1) Oil Groove
Main Bearing (Crank Case and Side Cover)
1. Remove the main bearing (1) with special tool.
(When reassembling)
Apply engine oil to all the fitting surface.
As shown at left, be sure to align the oil hole (2) on the crank
case and the bearing.
Drive in the bearing A and B deep below the side bearing
mounting face as shown at left.
Model
Crank Case
OC60-E2
Side Cover
Crank Case
OC95-E2
Side Cover
(1) Main Bearing
S-33
ENGINE
1.5 to 1.7 mm
0.059 to 0.067 in.
1.7 to 2.2 mm
0.067 to 0.087 in.
(2) Spring Pin
0000009243E
A B
1.0 mm 1.0 mm
0.039 in. 0.039 in.
0.5 mm 1.0 mm
0.020 in. 0.039 in.
0.5 mm 0.5 mm
0.020 in. 0.020 in.
(2) Oil Hole
0000009244E