Side Cover - Kubota WSM OC60-E2 Workshop Manual

OC60-E2, OC95-E2, WSM

(5) Side Cover

Side Cover
1. Remove the side cover mounting screws.
2. Tap the side cover lightly with plastic or wooden hammer to
separate it from cylinder block.
3. Hold the side cover with a hand and push the end of crankshaft
with thumbs to remove the side cover.
The side cover is fixed at two places by straight pins and
thus cannot be removed easily. Never try to pry it open
with a screwdriver, etc.
Remove the cover in parallel to the PTO shaft carefully to
prevent the oil seal from scraping the lip surface of the oil
seal.
When the side cover cannot remove due to the camshaft
comes out together with side cover, lift the both tappets
of intake and exhaust from injection pump installing
place.
(When reassembling)
There is no match marks on the balancer gear. Take the
following steps to install it.
1. Level the crankcase.
2. Place the piston to the top dead center.
3. Hold the side cover with both hands and make sure the
balancer weight faces straight downward.
4. Install the side cover, ensuring the oil seal's lip does not come
off.
When fitting the side cover, be sure to use the oil sealing
guide to prevent the oil sealing against peel-off and other
damages.
Timing Gear
(When reassembling)
The alignment marks (1) of the crank gear (2) and the cam
gear (3) must come together when the cam gear is installed.
(1) Alignment Marks
(2) Crank Gear
S-27
ENGINE
0000009229E
(3) Cam Gear
0000009230E