Kubota WSM OC60-E2 Workshop Manual page 82

OC60-E2, OC95-E2, WSM
Side Bearing
(When removing)
Lift up the side bearing by the flat screw driver as shown in
figure.
(When reassembling)
Make sure the oil groove (1) in the side bearing comes toward
the crank gear.
Make sure the anti-fall spring pin (2) for the side bearing is not
stretching out of the bearing surface.
Keep the spring pin head A above the surface (not greater
than the side bearing thickness as table below).
Do not confuse the above side bearing with that at the
crankcase.
OC60-E2
Spring pin head A
OC95-E2
(1) Oil Groove
Oil Seal
(When reassembling)
Place the side cover on the crankcase and drive in the oil seal
(3) with a special tool.
surfaces of the oil seal beforehand.)
The oil seal mounting hole is used for the socket and spigot
joint. Keep this hole 7 mm below the side cover as illustrated.
Use a special tool, because otherwise the oil hole may be
covered.
(1) Crankshaft
(2) Camshaft
(3) Oil Seal
S-30
1.5 to 1.7 mm
0.059 to 0.067 in.
1.7 to 2.2 mm
0.067 to 0.087 in.
(2) Spring Pin
0000009233E
(Apply oil to the inner and outer
[A] Direct Coupling
[B] 1/2 Camshaft Reduction
0000009234E
ENGINE