OC60-E2, OC95-E2, WSM
Disassembling Starter (OC95-E2)
(1) Motor
(2) Armature
(3) Yoke
(4) Spring
1. Disconnect the connecting lead (6).
2. Remove the two through bolts (8).
3. Detach the motor (1).
4. Draw out the brush (7) while holding the spring (4) up.
5. Remove the brush holder (5).
6. Draw out the armature (2) from the yoke (3).
7. Remove the housing (13).
8. Remove the idle gear (10) and the overrunning clutch (9).
9. Remove the end cover of magnet switch (12).
10. Remove the plunger (11).
(5) Brush Holder
(6) Connecting Lead
(7) Brush
S-39
(8) Through Bolt
(9) Overrunning Clutch
(10) Idle Gear
ENGINE
(11) Plunger
(12) Magnet Switch
(13) Housing