General Precautions - Kubota WSM OC60-E2 Workshop Manual

OC60-E2, OC95-E2, WSM

2. GENERAL PRECAUTIONS

During disassembly, carefully arrange removed parts in a
clean area to prevent confusion later. Screws, bolts and nuts
should be replaced in their original position to prevent
reassembly errors.
When special tools are required, use KUBOTA genuine
special tools. Special tools which are not frequently used
should be made according to the drawings provided.
Before disassembling or servicing live wires, make sure to
always disconnect the grounding cable from the battery first.
Remove oil and dirt from parts before measuring.
Use only KUBOTA genuine parts for parts replacement to
maintain engine performance and to ensure safety.
Gaskets and O-rings must be replaced during reassembly.
Apply grease to new O-rings or oil seals before assembling.
When reassembling external or internal snap rings, position
them so that the sharp edge faces against the direction from
which force is applied.
Be sure to perform run-in the serviced or reassembled engine.
Do not attempt to give heavy load at once, or serious damage
may result to the engine.
(1) Grease
(2) Force
(3) Place the Sharp Edge against
the Direction of Force
G-2
GENERAL
(A) External Snap Ring
(B) Internal Snap Ring
0000001277E