OC60-E2, OC95-E2, WSM
Motor Test (OC60-E2)
1. Disconnect the connecting lead to M terminal (1) and connect
a voltmeter across the lead and the body of the starter.
2. Connect a cable between the negative terminal of the battery
and the starter body.
3. Connect an ammeter and a switch in series between the
positive terminal of the battery and the connecting lead, and
run the starter.
4. The starter should run at the specified rate.
(1) M Terminal
Solenoid Switch (OC60-E2)
1. Check the continuity across S terminal (1) and M terminal (2),
and across S terminal (1) and the body with an ohmmeter.
2. If not continuous, replace.
(1) S Terminal
Motor Test (OC95-E2)
1. Remove the connecting lead (1) from the starter's C terminal
(2) and connect it directly to the battery's positive terminal.
2. Then connect the battery's negative terminal to the starter
body.
3. If motor rotates smoothly, it is O.K.
(1) Connecting lead
S-21
ENGINE
0000009399E
(2) M Terminal
0000009401E
(2) C Terminal
0000009389E