V3300-E2B, V3300-T-E2B, WSM
(4) Thermostat
(5) Injection Nozzle
Thermostat Assembly
1. Remove the thermostat cover mounting screws, and remove the
thermostat cover (1).
2. Remove the thermostat assembly (3).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) only at the
thermostat cover side of the gasket (2).
• Attach the thermostat with its hole facing toward the air suction
side.
(1) Thermostat Cover
(2) Thermostat Cover Gasket
Nozzle Holder
1. Secure the nozzle retaining nut (7) with a vise.
2. Remove the nozzle holder (1), and take out parts inside.
(When reassembling)
• Assemble the nozzle in clean fuel oil.
• Install the push rod (4), noting its direction.
• After assembling the nozzle, be sure to adjust the fuel injection
pressure.
Nozzle holder
Tightening torque
Overflow pipe nut
Nozzle holder assembly
(1) Nozzle Holder
(2) Adjusting Washer
(3) Nozzle Spring
(4) Push Rod
S-34
DIESEL ENGINE
(3) Thermostat Assembly
(4) Hole
W1072747
34.3 to 39.2 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
19.6 to 24.5 N·m
2.0 to 2.5 kgf·m
14.5 to 18.1 ft-lbs
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 ft-lbs
(5) Distance Piece
(6) Nozzle Piece
(7) Nozzle Retaining Nut
W1089102
KiSC issued 06, 2006 A