Dog trace d–control 440 User Manual page 7

Electronic vibration training collar – set for training a single dog electronic vibration training collar – set for two dogs

Hide thumbs Also See for d–control 440:

Table of Contents

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE REMOTE CONTROLLER

Remove the cover of the battery compartement and insert a new 3V CR2 battery.

Mind the correct polarity marked in the battery compartement.

Replace the cover and tighten the screw.

NOTICE: you can also use rechargeable batteries in the remote controller. They do not provide

enough voltage for correct battery status indication on the LCD.

Checking the battery status

Look at the LCD display to check the battery status:

Fully charged battery: full battery symbol shines in the LCD permanently in on state.

Weak battery: LCD display indicates battery capacity decrease. In case the battery symbol

is empty, insert a new 3V CR2 battery according to the instructions above.

Make sure that the receiver works correctly.

ADVICE: The battery can be

removed more easily using a small

screwdriver placing it under the

battery edge carefully.

CAUTION: Always switch oﬀ the

remote controller before battery

removal! Remove the battery and

shortcut battery contacts using

a metal tool.

Battery compartment

Table of Contents

D–control 442