Dog trace d–control 440 User Manual page 11

Mode setting is done using buttons (vibration mode setting) on the remote controller.
Transmission symbol appears on the remote controller LCD display.
A red LED diode on the receiver is lit permanently.
Button – lighting the collar
A red LED diode inbuilt in the collar emits very intensive fl ashes which are stronger than by common
light collars. Your dog can be easily located even in absolute darkness! There are 8 interesting
fl ashing modes available.
Mode Function
0 pressing shortly – single blink
1 pressing permanently – blinking as long as the button is pressed
2 pressing shortly – blinking 10times
3 after pressing – a blink in every 5 seconds
4 same function as mode 0 with a diff erent fl ashing frequency
5 same function as mode 1 with a diff erent fl ashing frequency
6 same function as mode 2 with a diff erent fl ashing frequency
7 same function as mode 3 with a diff erent fl ashing frequency
NOTICE: By modes 3 and 6 do not forget to switch off blinking by pressing the light button.
Modes 4–7 can be used for diff ering dogs in darkness.
SETTING THE MODES:
Press a dog selection button A or B (depending on which button the required receiver
is paired) until symbol A or B starts blinking on the LCD.
Set the required mode number (0–7) using the correction impulse setting arrows.
Confi rm the selection by pressing button A or B again.
11