Front Connection; Rear Connection - Davolink DV-332 User Manual

DV-332 Analog/Digital User Guide

3.1.1 Front connection

1) How to connect Ethernet ports
Please connect xDSL(ADSL, VDSL) or other Ethernet connections to the WAN port. You can connect
PC to LAN ports. Since it is a hub port, you need to additionally allocate an IP address to PC.
2) Console connection
You can use a console cable at the initial configuration. The connection speed of a console is
19.2Kbps. You have to use the exclusive console cable provided with the product.
3) Gateway status indication LEDs
* PWR : This LED lights up when the power supply is provided. When the LED does not light up even
after turning on the on/off switch, you need to check power supply and fuse.
* STS : This LED represents the gateway status and lights up when there is a problem. It could be lit
up when the WAN port is not connected or during the booting process. Otherwise, there are
hardware-related problems.
* WAN & LAN : These LEDs light up when they are physically connected.
4) Port status indication LED
This LED will be turned off when the port is IDLE. When the port receives a call, the LED will be lit
up for 1 second and turned off for 2 seconds. Moreover, it will be lit up continuously when the line
is busy.

3.1.2 Rear connection

1) There is a fuse box between the power supply port and on/off switch. Basically there are 2 fuses
available and the unused one is a spare one. You have to check the fuse when GW does not work
even after turning on the power.
2) Analog port connection(s)
Basically DV-332 provides 4 analog port slots. And you can insert additional 4FXS/4FXO module or
12