Davolink DV-332 User Manual page 78

DV-332 Analog/Digital User Guide
- Activating Auto upspeed mode
GW/CONFIG/FAX> change aup enable
Remote GW changes into media session (G.723.1, G.726) which is already connected & other
PCM Codec without Re-INVITE, GW is also changed to PCM Codec automatically.
When sending GW detects CNG tone, it changes to PCM Codec without Re-INVITE
automatically.
- Setting FAX event
Some FAX Event are detected, select whether T.38 FAX procedure is executed or not.
GW/CONFIG/FAX> change lced [ft38 | mt38]
GW at receiving party detects CED tone, start T.38 FAX.
FT38 changes to T.38 mode without Re-INVITE so it sends udptl message.
MT38 changes to T.38 mode after Re-INVITE procedure.
GW/CONFIG/FAX> change lcng [f711 | m711]
GW at sending party detects CNG tone, start T.38 FAX.
FT38 changes to T.38 mode without Re-INVITE procedure so it sends udptl message.
MT38 changes to T.38 mode after Re-INVITE procedure.
/* Specific FAX sort is unable to send CNG tone.*/
GW/CONFIG/FAX> change lv21 [f711 | m711]
When GW at receiving party detects V.21 flag, start T.38 FAX.
FT38 changes to T.38 mode without Re-INVITE so it sends udptl message.
MT38 changes to T.38 after Re-INVITE procedure.
GW/CONFIG/FAX> change rfax [f711 | m711]
GW at sending party detects FAX tone (CED) from receiving party, execute T.38 FAX.
FT38 changes to T.38 mode without Re-INVITE & sends udptl message.
MT38 changes to T.38 mode after Re-INVITE procedure.
78