Davolink DV-332 User Manual page 55

If you type "change" command as follows, you can see the usage.
GW/CONFIG/AR2> change
==========================================================================
Configuration Change Command Usage
==========================================================================
change <parameter> <value>
==========================================================================
parameter ; dmode - dialing(address sending) mode
; stype - R2 line signaling type
; rsend - ringback tone send in seizure
; ftvc - off tone on opening of voice channel
; prsend - pseudo ringback tone send
; asend - alert message send to network
; sdt
; t1
; t2
; t3
; t4
; t5
; t6
; t7
; t8
; t9
; t10
; t11
; t12
; t13
; icbt - Ignoring CG/Busy Tone
; prel
; ia6
value ; dmode - overlap|enbloc
; stype - wink(wink-start)
; dsend,rsend - on|off
; ftvc - after 0 ~ 59 sec, 60 = off
; prsend - off|setup|callproc
; sdt
; t1~11
; t3
; t4,12,13 - 100 ~ 10000 (ms)
; t8,10
; icbt - on | off
; prel|ia6 - on | off
==========================================================================
GW/CONFIG/AR2>
DV-332 Analog/Digital User Guide
- speed dial timeout
- Seizure Guard Time
- Clear Foward Guard Time
- Clear Foward Wait Guard Time
- Seizure Ack Guard Time
- Seizure Ack Duration
- Answer Guard Time
- Clear Backward Guard Time
- Release Guard Time
- Reanswer Guard Time
- Release Wait Guard Time
- Block Detect Guard Time
- Glare Detect Guard Time
- If glare is detected, stay seizure
- Playing REL-tone to the R2
- Ignoring ACOMP(A6|A3) sig
- 1 ~ 10 sec
- 0 ~ 1000 (ms)
- 1000 ~ 60000 (ms)
- 0 ~ 10000 (ms)
[O/G]
[I/C]
[I/C]
[I/C]
[O/G]
[I/C]
[I/C]
[I/C]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[O/G]
[E1]
55