Table of Contents
Advertisement
4.2.2 Cable connection
After the equipment is in place, refer to Figure 6 for how to connect the cable
to the DV-302 rear panel.
4.2.3 Connecting Ethernet Cable
The Straight cable is also used to connect the LAN port to a terminal-like workstation, PC, or
notebook. When connecting the LAN port to a HUB, Straight-through or Crossover
unshielded twisted pair (UTP) category 5 cables can be used as shown in Figure 8.
FIGURE 3. DV-302 REAR INTERFACE
NOTE
Maximum length of RJ-45 should be less than 85m.
FIGURE 4. RJ-45 CABLE (UTP CABLE)
1 2 3 4 5 6 7 8
1 : Rx +
2 : Rx -
3 : Tx +
6 : Tx -
FIGURE 5. ETHERNET PORT PIN CONNECTION
DV-302 OPERATION MANUAL
PC Port
11
Advertisement
Table of Contents
