Davolink DV-332 User Manual page 54

DV-332 Analog/Digital User Guide
Dial interval (intv)
Dial Tone Type (dtype)
------------------------------------------------------
Seizure Guard Time (t1)
Clear Foward Guard Time (t2)
Clear Foward Wait Guard Time (t3)
Seizure Ack Guard Time (t4)
Seizure Ack Duration (t5)
Answer Guard Time (t6)
Clear Backward Guard Time (t7)
Release Guard Time (t8)
Reanswer Guard Time (t9)
Release Wait Guard Time (t10)
Block Detect Guard Time (t11)
Glare Detect Guard Time (t12)
If glare is detected, stay seizure(t13)
Ignoring CG/Busy Tone(icbt)
==========================================================================
GW/CONFIG/AR2>
Most of default values above are widely used ones. Therefore, you do not have to change them
when installing and configuring. Sometimes you can change following options.
dialing Mode (dmode)
Overlap mode sends each digit right after pressing it. And enbloc mode stores whole digits and send
them later.
ringback tone send in alert (rsend)
plays ringback tone or not.
alert msg send to network (asend)
network.
I/C Calling Party Addr Request (sareq)
requests the calling number to sender. If it is off, calling numbers will not be shown.
wait second digit timer (sdwt)
up this time too short, a call can be made during the dialing process.
wait post digit timer-Enbloc Peer (pdwt)
: 500 ms
: This field defines the method to send dialed digits via lines using R2 MFC.
: After receiving alerting message, this field defines whether GW
: This field defines whether GW sends alerting message to
: When receiving a call, this field defines whether GW
: This field defines the a waiting time between two digits. If you set
: This field defines a waiting time after dialing.
: 100 ms
: TONE_DIAL_CONT
: 60 ms
: 200 ms
: 30000 ms
: 1000 ms
: 360 ms
: 200 ms
: 200 ms
: 200 ms
: 200 ms
: 1000 ms
: 640 ms
: 200 ms
: OFF
54