Setting Up Call Transfer Feature - Davolink DV-332 User Manual

DV-332 Analog/Digital User Guide
===========================================================================
* ADDRESS TABLE SHOW *
===========================================================================
INTF PORT VIRTUAL_NUM
===========================================================================
FXS 0 200
FXS 1 201
FXS 2 202
FXS 3 203
FXO 0 100
FXO 1 101
FXO 2 102
FXO 3 103
===========================================================================
GW/CONFIG/ADDRESS>
As setting above, for example, if the phone connected to FXS number 0 port rings, hold the phone
connected to number 3 port & press "0". Then, receiving calls can answer from number 3ports..

8.5.2 Setting up call transfer feature

When PSTN line is receiving a call through IP or FXO, it will establish the connection to another port.
To setup this function, local call feature mode(va) shall establish with "yes". This helps GW to
perceive hook flash when connecting the call to another port. Otherwise, it takes the call as
disconnection without perceiving hook flash. Therefore, it needs to check the following
establishment related to hook flash.
GW/CONFIG/FXS> show
===========================================================================
FXS Configurations Show
===========================================================================
Voice Output Gain
-2 -2 -2 -2
PCM Input Gain
0 0 0 0
Caller id Generation mode
DISABLE DISABLE DISABLE DISABLE
ring cadence on time (ron)
ring cadence off time (roff)
Polarity reversal (pola)
Dial Tone Type (dtype)
PEER-ADDR
NONE 200
NONE 200
NONE 200
NONE 200
200
201
202
203
(vgain) : dB
(igain) : dB
(cid) :
: 1 sec
: 2 sec
: DISABLE
: CONTINUOUS
84
GROUP-PORT MODE
Round_Robin C/1ST
Round_Robin C/1ST
Round_Robin C/1ST
Round_Robin C/1ST
None
None
None
None
L/RT
C/1ST
C/1ST
C/1ST
C/1ST