Setting The Function For Showing Caller Id - Davolink DV-332 User Manual

DV-332 Analog/Digital User Guide
Post digit timeout(pdt)
hook flash guard time (guard)
Ring Vrms Value
60 60 60 60
CODEC filter value
No answer timer(natimer)
FXS/FXO|LBU One2One Mode(one2one)
DISABLE DISABLE DISABLE DISABLE
FXO unblock time(ubtime)
DTMF duration (dur)
DTMF interval (intv)
Wait dialtone (wdt)
Ringing timer (ringing)
Early DTMF (edtmf)
Early DTMF Onhook guard (etime) : 1 sec
Force On-Hook (fon)
ForceOn-HookGuardTimer(ontimer) : 10 sec
Ring trip threshold (rtrip)
FXS Codec Receive Gain (rg)
Private ring number(pri)
===========================================================================
GW/CONFIG/FXS>

8.7 Setting the function for showing caller ID

Generally, shown caller ID is that a function of detection. Information of number from PSTN line
shall detect when telephone signal arrives to receiver party. Then, this information will provide to
the phone which connected to FXS port. Normally, domestic Ring signal provides 1 second & 2
seconds take off. And then, Ring signal provides 1 second. It's the type of ring signal in our nation.
Information of caller ID delivers during the interval between the first Ring signal & second Ring
signal. For this interval (2 seconds), it delivers by FSK method.
: 2 sec
: 600 ms
(vrms) :
: KOREA
: 180
:
: 500 ms
: 120 ms
: 60 ms
: 2 sec
: 200 sec
: DISABLE
: DISABLE
: DOWN
: OFF
: none
88