Setting Up Digital Trunk Port; Clock Configuration - Davolink DV-332 User Manual

6. Setting up digital trunk port

6.1 Clock configuration

When digital ports are physically connected to PSTN lines or PBX, you will see the SYNC and ALM
LED turned on. After being synchronized, the ALM LED will be turned off. Therefore, you should only
see the SYNC LED turned on. You can set up clock source in /CONFIG/COMMON.
GW/CONFIG/COMMON>
==========================================================================
==========================================================================
yes/no prompt mode
watchdog timer
# Processing Mode
web mode
telnet mode
telnet keepalive timer
local call feature mode
ethernet wan speed type
ethernet lan speed type
telnet port
web port
digitmap mode
UPS mode
primary clock source
long/short haul transceiver
dtu block mode when wan link down (wblmode) : LOGICAL
dtu block when dtu link down
dtu relay control
pcm_coding_law
Company name
==========================================================================
GW/CONFIG/COMMON>
In order to synchronize clock source, one should be Master and the other one should be Slave. You
have 3 options as follows. Default value is NORMAL0.
FREERUN : Using the clock of GW itself in synchronization. (Master)
DV-332 Analog/Digital User Guide
show
Common Configurations
(prompt)
(wdt)
(dtp)
(web)
(telnet)
(keep)
(va)
(wan)
(lan)
(tport)
(wport)
(digitmode): YES
(upsmode) : NO
(clkp)
(haul)
(dblchk)
(drelay)
(pcm)
(com)
: YES
: YES
: END_OF_DIGIT
: YES
: YES
: 0 (sec)
: YES(pickup number : *0)
: AUTO
: AUTO
: 6000
: 8000
: NORMAL0(slave0)
: LONGHAUL
: NO
: OFF
: PCM_ALAW
: DAVOLINK
49