DV-332 Analog/Digital User Guide
10. Saving, initializing, checking configured information
10.1 Saving configuration
After changing, adding, or removing configuration, you can save it into text file as follows. You can
use these commands: "save" or "make".
GW/CONFIG/TXTCFG>
TConfig Writing Done
GW/CONFIG/TXTCFG>
TConfig Writing Done
GW/CONFIG/TXTCFG>
10.2 Initializing confgiruation
GW/CONFIG/TXTCFG>
GW/CONFIG/TXTCFG>
GW/CONFIG/TXTCFG>
-------[MEM][40]--------
[TEXT_CONFIG_START]
[TEXT_CONFIG_END]
[USER_END]
-------[END]--------
GW/CONFIG/TXTCFG>
If you initialize configuration by typing commands above, entire configuration you made before will
be initialized.
*** Note: IP settings will not be initialized even when initializing configuration. And you should save
configuration before resetting.
10.3 Backuping and resaving configuration
This is another way to show current configuration as a whole and input it at once. You can print out
current configuration and copy&paste it as follows.
save
make
default
show
102