Additional Configuration In Calls Between Headquarter And Branches - Davolink DV-332 User Manual

FXO 202 *2???

7.2 Additional configuration in calls between headquarter and branches

** Following configuration is only required in SIP service. You do not need extra configuration in
H.323 service.
These are additional steps except for routing and address tables.
1) Enabling local call feature in a gateway
To enable calls within one gateway, you can do that with the following command.
GW/CONFIG/VOIP> lcall enable
GW/CONFIG/VOIP> lcall
Usage : lcall [ enable | disable ]>
Current lcall mode : ENABLE
GW/CONFIG/VOIP>
2) Receiving unregistered numbers between headquarter and branches
Normally GW uses unregistered numbers to SIP (for instance, *100???, *200???, **12, #1?? and so on)
to distinguish headquarter-branch call from normal one. In order to do that, you should allow GW to
use these calls by a following command. Default value is "YES".
GW/CONFIG/VOIP> allowxto
usage : allowXto y|n
current allowXto(allow invalied to) value is NO
GW/CONFIG/VOIP> allowxto yes
GW/CONFIG/VOIP> allowxto
usage : allowXto y|n
current allowXto(allow invalied to) value is
GW/CONFIG/VOIP>
DV-332 Analog/Digital User Guide
2
YES
0.0.0.0
69