Setting Codec - Davolink DV-332 User Manual

Post digit timer(pdt)
Wait mode (wm)
Dialtone timer(dt)
Fxo dial connect mode(dcm) :
Passwd_mode (pm)
Password (ps)
Fxo password timer (pt)
Wait dialtone time(wd)
Wait digit timer(wdt)
Wait connect from net (t2) :
Wait digit from net (t4)
Release tone play (rtp)
Silence Detection (sd)
Silence Period (sp)
Silence Level (sl)
CallerID detection(caller) :
DISABLE, DISABLE, DISABLE, DISABLE
CallerID_detect_timer(dct) :
Ring guard timer
H/W ring det. (hwring)
Connect mode (connect)
Flash hook time (fhtime)
Force release time (frtime) :
Fxs busy (sbusy)
Fxo offhook timer(off)
Fxo ringing polling(rpoll) :
========================================================================
GW/CONFIG/FXO>
Setting of vgain & igain shall establish as same as FXS port. Default for FXS & FXO port are vgain = -
2dBm, igain = 0dBm.

8.4 Setting Codec

GW uses codec that has compression function. It applies to convert 64Kbps of analog voice to digital
information. This codec classifies according to compression rate & compression algorithm. Usually,
G.723.1, G.729A, G.711a, G.711u are often using as normal Codec. G.723.1 is for 6.3K or 5.3K,
G.729A is for 8K, G.711a/G.711u are for 64K. These codecs convert voice to digital information.
GW/CONFIG/VOIP> vocoder
DV-332 Analog/Digital User Guide
: 2 sec
: DIALTONE MODE
: 12 sec [Dialtone mode] [PSTN-->FXO]
disable
: disable
: 1002
: 3 sec [PASSWORD MOD]
: 1500 ms
: 7 sec [Announce mode] [PSTN-->FXO]
60 sec
: 500 ms
: 4 sec
: Disabled
: 120 sec
: -50 dBm
4000 ms
(rguard): 410 ms
: 2
: 0(wait the answer back) [PSTN-->FXO-->IP]
: 500 ms
0 minute
: NOANSWER
: 0 sec
13 msec
[PSTN-->FXO]
[Dialtone mode] [PSTN-->FXO]
[PSTN-->FXO]
[PSTN-->FXO]
[FXO-->PSTN]
[FXO-->IP]
[IP-->FXO]
[FXO-->PSTN]
[PSTN-->FXO]
[PSTN-->FXO]
[PSTN-->FXO]
[PSTN-->FXO]
[PSTN-->FXO]
[PSTN-->FXO]
[FXO-->PSTN]
[FXO<-->IP]
[FXO-->FXS]
[IP-->FXO]
[PSTN->FXO]
81
[PSTN-->FXO]