NETGEAR D6400 User Manual page 23

AC1600 WiFi VDSL/ADSL Modem Router Model D6400
7. Connect the power adapter to the modem router and plug it into an electrical outlet.
Wait for the Power LED
8. If the Power LED does not light, press the Power On/Off button.
9. Wait for the WiFi LED
If the WiFi LED does not light, press the WiFi On/Off button
10. Check the DSL LED.
If the modem router is connected to a DSL service, the DSL LED
11. Connect a computer to the modem router by one of the following methods:
• Ethernet cable. Use an Ethernet cable to connect your computer to a yellow Ethernet
LAN port on the modem router.
The product package contains a yellow Ethernet cable.
Your computer connects to the modem router's LAN.
• WiFi. Connect to the default WiFi network of the modem router:
a. On your computer or WiFi device, find and select the WiFi network.
The WiFi network name (SSID) is on the product label.
b. Join the WiFi network and enter the WiFi password.
The password (network key) is on the product label.
Your computer or WiFi device connects to the modem router's WiFi network.
Note: If the computer is set to a static (fixed) IP address (this setting is
uncommon), either change the computer to obtain an IP address
automatically from the modem router through DHCP, or change the IP
address of the computer to a static IP address in the
192.168.0.2–192.168.0.254 range.
12. Launch a web browser.
The NETGEAR genie automatic setup utility displays. (This utility is also called the Setup
Wizard.)
Install and Access the Modem Router and Its Network
to light solid green, which takes about one minute.
to light blue.
23
.
lights green.