NETGEAR D6400 User Manual page 67

AC1600 WiFi VDSL/ADSL Modem Router Model D6400
7. Enter the cable or fiber settings as described in the following table.
Field
Select Country
Select Internet Service
Provider
Transfer Mode
DSL Mode
Enable This Interface
Multiplexing Method
VPI
VCI
Use VLANID
Priority (802.1p)
Account Name (If Required)
Domain Name (If Required)
Internet IP Address
Get Dynamically from ISP
Use Static IP Address
Use IP over ATM (IPoA)
Description
Select the country in which you use the modem router.
Select the Internet service provider (ISP) that you are using.
If your ISP is not in the menu, select Other.
These settings are not disabled but do not apply to a cable or fiber
connection. You can ignore these settings.
Make sure that WAN1 is selected from the menu and that the Enable This
Interface check box is selected. These are the default settings.
Note: For information about interface WAN2, see
Interface for IPTV on page 197.
These settings are not disabled but do not apply to a cable or fiber
connection. You can ignore these settings.
Select the Use VLANID check box and enter the VLAN ID, as indicated by
your ISP.
A VLAN ID might be required if you subscribe to both Internet service and
IPTV service. If your ISP did not provide you with a VLAN ID, leave the Use
VLANID check box cleared, which is the default setting.
For information about setting up VLAN tag groups, see
a VLAN Tag Group on page 202.
If your ISP provided you with a VLAN ID and a priority value, enter the
priority value, which is a number from 0 to7.
You can enter a priority value only in combination with a VLAN ID. If your
ISP did not provide you with a priority value, leave the default setting (0).
Enter the account name, as indicated by your ISP. This name might also be
called the host name.
If your ISP did not provide you with an account name or host name, leave
this field blank.
Enter the domain name, as indicated by your ISP.
If your ISP did not provide you with a domain name, leave this field blank.
Your ISP uses DHCP to assign your IP address. Your ISP automatically
assigns these addresses.
Enter the IP address, IP subnet mask, and gateway IP address that your
ISP assigned you for static IP address service. The gateway is the ISP
router to which your modem router connects.
Enter the IP address, IP subnet mask, and gateway IP address that your
ISP assigned you for IPoA service. The gateway is the ISP router to which
your modem router connects.
Manage the Internet Settings Manually
67
Enable the WAN2
Set Up a Bridge for