First Operation; Instruction; Initial Charging Procedure; Prior To Starting Up - HAKO Scrubmaster B100R Instruction Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before first oper-
ation. First instruction into handling of
the machine must be held by a qualified
person sent by your local Hako contract
dealer. Your Hako dealer will be in-
formed by the manufacturer upon deliv-
ery of the machine and will contact you
to make a date for instruction.
2.2

Initial charging procedure

Before first operation of the
machine, fully charge the bat-
tery with an initial charging pro-
cedure and comply with the op-
erating instructions of the
charger as well as with those of
the battery manufacturer.
Hako cannot be held liable for
damages resulting from an in-
sufficient initial charge.
2.3

Prior to starting up

1. Check the parking space for signs of
leaks. Hoses, lines and tanks must
show no signs of leaks or damage.
2. Check that the brushes and squee-
gee are mounted, refer to Chapter
"Maintenance".
3. Check that the solution tank is filled
and the recovery tank is empty.
4. Check that the battery plug is con-
nected, refer to Chapter "Mainte-
nance".
2.4

Switching the vehicle on

Do not actuate the direction switch.
1. Check that the main fuse lever is at
the top.
2. Insert the ignition key in the key
switch and turn from position (0) to
position (1).
3. Check the battery indicator to ensure
that the battery is sufficiently
charged.
2.5

Operation

1. Switch the vehicle on.
2. Set the direction switch to forward or
reverse.
3. Set the function selection switch to
drive mode.
4. Tread on the throttle slowly to start
moving. – On releasing the throttle,
the machine stops and when at a
stop, the parking brake is activated.
5. Drive the vehicle in drive mode to the
site which is to be scrubbed and vac-
uumed.
6. Set the function selection switch to
scrubbing with vacuuming (green
field). – If only scrubbing or vacuum-
ing is required, set the function se-
lection switch to the corresponding
field.
7. Starting up. – The brush head and
squeegee are lowered automatically
and start operating.
8. In the case of stubborn dirt, set the
function selection switch to the field
with the weight symbol to increase
the brush pressure. – The vehicle
should not be operated permanently
with increased brush pressure.
9. On completing the scrubbing and
vacuuming operation, set the func-
tion selection switch back to drive
mode.
11