Table of Contents
Advertisement
Section2. Aileron Servo & Linkage
Installation
Step1. Locate the items shown in picture. (Servos
sold separately.)
Step2. Use a hobby knife to remove the coverings
for the inboard servo and servo lead.
Step3. Thread the servo arm through the wing out
of the hole as shown.
(The distance between the hole and the opening
for servo is about 260mm (10.2inch), you need to
use a servo extension if your servo lead is not
enough long.)
www.valuehobby.com/aviator-trainer-25-arf.html
Step4. Use a drill bit to drill four mounting holes for
the servo.
Step5. Install the servo onto the wing using four
self-tapping screws provided with the servo.
Step6. Prepare a servo arm with pushrod
connector.
Step7. Install the servo arm to the servo.
(Remember to center the servo before this.)
8
Advertisement
Table of Contents
